In alternative, you can contact the seller that sold you the FTDI Programmer. If you have a brand new FTDI Programmer and you need to install your FTDI drivers on Windows, visit this website for the official drivers. Unbricking the FTDI Programmer on Windows PC It should have a green arrow in the bottom left. How does the NodeMCU flasher should look after a successful flash? I don’t have any logical explanation, since this is not very common. So at a baud rate of 57600 or 115200 I think it will flash 100%. I don’t know why, but at least 5 people faced the same problem and this trick solved it. If this process fails, please repeat the same procedure for the next baud rates (38400, 57600, 74800). Open NodeMCU flasher and try the 19200 baud rate.Plug your ESP+FTDI to your computer again.NodeMCU flasher gets stuck at a certain percentage Problem 2 – If your FTDI can’t supply enough current, you might need to buy a new FTDI programmer or power your ESP8266 with an external power supply. Repeat steps 2 and 3 a few times until your ESP reboots and hopefully the NodeMCU flasher can detect your ESP and start the flashing process.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |